Bent-Knee Hip Raise is a beginner core exercise you can do with no equipment. Below is the full movement, step by step, with the form cues and common mistakes that matter most.
At a glance
| Body area | Core |
|---|---|
| Difficulty | Beginner |
| Equipment | None — bodyweight only |
| Main muscles | Abdominals |
| Movement pattern | Pull |
| Steps | 3 |
Muscles worked
The work lands almost entirely on your abdominals, so Bent-Knee Hip Raise is a targeted exercise rather than a general one.
The pattern here is pull. Follow it with a pushing movement in the same session and the workout stays balanced.
How to do it
Step 1
Lie flat on your back with your arms at your sides, bend your knees to about 75 degrees, and lift your feet 2 inches off the floor.

Step 2
Pull your knees toward your chest while keeping the 75-degree bend, roll your pelvis backward, and raise your hips off the floor until your knees are over your chest.

Step 3
Squeeze your abs at the top for one second, then lower your hips and return your feet to the starting position with control.

Form cues
- Keep your arms flat at your sides for stability.
- Maintain a 75-degree bend in your knees throughout.
- Press your lower back gently into the floor.
- Engage your lower abs to initiate the movement.
- Keep your knees bent at the same 75-degree angle—do not straighten them.
- Roll your pelvis backward as your hips lift.
- Bring your knees directly over your chest at the top.
- Squeeze your abdominal muscles firmly at the top.
- Lower your hips slowly and deliberately.
- Return to the starting position with the same controlled pace as the lift.
- Keep your feet 2 inches off the floor at the bottom.
Common mistakes
Feet resting on the floor. Lift your feet 2 inches off the ground and hold them there.
Knees straightening or locking. Keep your knees bent at 75 degrees—do not straighten your legs.
Arms moving away from sides. Keep your arms flat and still next to your body for balance.
Straightening the knees during the pull. Maintain the 75-degree knee bend throughout—use your abs, not your legs.
Using momentum instead of controlled abs. Move slowly and deliberately; control the motion with your core.
Lifting hips without rolling the pelvis. Roll your pelvis backward as you lift to engage your lower abs fully.
Dropping hips quickly or using gravity. Lower your hips at the same slow speed as you lifted them.
Letting feet touch the floor between reps. Keep your feet hovering 2 inches above the floor—do not rest them.
Losing tension in the abs during the return. Maintain abs engagement throughout the entire lowering phase.
Breathing
- Exhale as you pull your knees in and lift your hips.
- Inhale as you lower your hips back to the starting position.
How to program it
Reel Motion starts you at 3 sets of 10, with 1 min of rest in between, which comes to about 3 min 30 sec in total. Change the numbers before you change the technique.
| Sets | 3 |
|---|---|
| Reps per set | 10 |
| Rest between sets | 1 min |
| Total time | about 3 min 30 sec |
Safety
- Do not arch your lower back excessively; keep it neutral and in contact with the floor.
- Do not use your arms to push or assist; keep them still at your sides.
- Avoid jerky or bouncing movements; maintain smooth, controlled motion.
- Do not allow your lower back to arch excessively as you return to start.
Where it fits in your training
Once the last set still looks clean, Gorilla Chin/Crunch is the next step up in the same pattern. For a change at the same level, swap in Air Bike.
Related exercises
More core movements in the Reel Motion library:
- Cross-Body Crunch — beginner
- Flat Bench Lying Leg Raise — beginner
- Hanging Leg Raise — advanced
- Jackknife Sit-Up — beginner




